Company Introduction
Our Factory
Development History
Company Culture
Our Certificates
Application Area
Products Video
Enterprise News
Industry News
Please click on the upper right corner
Share it with your circle of friends
Pairing the remote control with the Aglare LED Floodlight is usually a simple process. Here is a detailed step-by-step guide to help you complete the pairing:
Preparation
Preparation
1. Ensure power: Make sure the Aglare LED Floodlights is connected to a power source and turned on.
2. Check the remote control: Make sure the remote control has sufficient power and is not damaged.
Pairing steps
1. Enter pairing mode
• Find the setup button: Find the "Setup" or "Pairing" button on the Aglare LED Floodlight. This button is usually located on the bottom or side of the light.
• Press and hold the setup button: Press and hold the "Setup" or "Pairing" button for a few seconds until the light starts flashing or displays an indicator light, indicating that it has entered pairing mode.
2. Using the remote control
• Find the pairing key: Find the "Pairing" or "Setup" button on the remote control. Some remote controls may require a specific key combination to be pressed.
• Press the pairing key: Press and hold the "Pairing" or "Setup" button on the remote control for a few seconds.
• Wait for confirmation: When the light stops flashing and remains on or displays a specific indicator light, it means that the pairing is successful.
Specific steps Example
Enter pairing mode
1. Find the setup button: Find the "Setup" or "Pairing" button on the Aglare LED Floodlight.
2. Long-press the setup button: Long-press the "Setup" or "Pairing" button for 5 seconds until the light starts flashing.
Using the remote control
1. Find the pairing key: Find the "Pairing" or "Setup" button on the remote control.
2. Press the pairing key: Press and hold the "Pairing" or "Setup" button on the remote control for 5 seconds.
3. Wait for confirmation: When the light stops flashing and remains on, it means the pairing is successful.
Common problems and solutions
1. The light does not flash or respond
• Check the power supply: Make sure the light is properly connected to the power supply and turned on.
• Check the remote control: Make sure the remote control has sufficient power and is not damaged.
• Retry pairing: Try to enter pairing mode again.
2. The remote control cannot control the light
• Check the frequency: Make sure the remote control and the light are using the same frequency.
• Clear interference: Make sure no other electronic devices are interfering with the signal.
• Reset the light: Reset the light according to the instructions in the user manual and then pair again.
3. The light keeps flashing
• Check the pairing status: Make sure the light has been successfully paired and stops flashing.
• Re-pair: If the light keeps flashing, try re-pairing.
Where is the Aglare LED Floodlight used?
The Aglare LED Floodlight is very suitable for amusement parks, stages, parties, billboards, playgrounds, and landscapes due to its rich color changes and flexible control characteristics.
Summary Through the above steps, you can easily pair the remote control with the Aglare LED Floodlight. If you encounter any problems during the pairing process, it is recommended to consult the user manual or contact Aglare's customer support. I hope this information can help you successfully complete the pairing and use your Aglare LED Floodlight.